Switch King - Forum

I just set up two lights, one is controlled by a CMR-100 and the other one LWMR-210 (both nexa products).
I created two new devices in SwitchKing and the I pressed "Learn" on the Device1 in SwitchKing and I did the same thing on the light. This was the LWMR-210.
It worked as it should, off and on, no problem.
Then I did the same thing to the CMR-100 (it's set to the nr 6 setting). And here my problems started.. If I turn Device 1 on / off, the same thing happens to Device2!... If I try to turn on / off Device2 in SwitchKing, nothing happens.

If I use my Nexa Self learning switch, I can connect the the CMR-100 and turn in on and off with that. But I want my TellStick Duo to controll everything. I tried to delete the CMR-100 and added it again, same problem.. What am I doing wrong here?

I'm new to Switchking / nexa / tellstick.

It sounds like you have learned the two devices the same code by mistake. As a first step, you should reset the memory of the CMR-100 and relearn it with a new code.

Yep! That was the problem.